CWF HT-ed 3V 64rc hunter knife

1 Comment Uncategorized

CPM 3V, 0.09″ thick, hollow grind
Sharpened edge 32-34 inclusive angle
0.01″ behind edge thick

What happen when using a sharp edge to whittle 16D nail.

Edge after whittled nail

One thought on “CWF HT-ed 3V 64rc hunter knife”

  1. Ken Holland says:

    That camphor burl sure looks nice as a handle – never thought about using camphor. Good job!

    With the thinner edge using CWF it sure looks like your HT leaves an edge stronger than the fabled Peter’s HT.

    Ken H>

Leave a Reply

Your email address will not be published. Required fields are marked *